| 引用本文: | 黄战, 戴冠中.基于Tuning-Knobs的智能化自校正控制CAD*[J].控制理论与应用,1991,8(3):308~315.[点击复制] |
| Huang Zhan, Dai Guanzhong.Tuning-Knob-Based Intelligent CAD of Self-Tuning Control Systems[J].Control Theory and Technology,1991,8(3):308~315.[点击复制] |
|
| 基于Tuning-Knobs的智能化自校正控制CAD* |
| Tuning-Knob-Based Intelligent CAD of Self-Tuning Control Systems |
| 摘要点击 1033 全文点击 541 投稿时间：1989-10-16 修订日期：1990-01-24 |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| DOI编号 |
| 1991,8(3):308-315 |
| 中文关键词 专家系统 CAD 智能前端 自校正控制 Tuning-Knobs |
| 英文关键词 expert system CAD intelligent front end self-tuning control tuning-knob |
| 基金项目 |
|
| 中文摘要 |
| 本文提出了一种很适合于专家系统开发的基于Tuning-Knobs的自校正控制系统启发式CAD过程，并讨论了一些典型的Tuning-Knobs调整规则，在此基础上，我们用Turbo Prolog语言为某自校正控制系统CAD软件包（SELFPAC,用C语言编写）开发了智能前端。 |
| 英文摘要 |
| In this paper, a “tuning -knob-based ” heuristic CAD procedure for self-tuning control system which is very suited for an expert system development is proposed. Tuning rules for some common ”tunig-knobs” are discussed. Based on this, a prototype implementation of an expert system which acts as an intelligent front end for a self-tuning control system CAD package (SELFPAC, written in C) is developed in Turbo-Prolog. |