| 引用本文: | 葛建华,孙优贤.容错控制系统部件重要度计算的CAD算法[J].控制理论与应用,1993,10(3):340~345.[点击复制] |
| GE Jianghua and SUN Youxian.A CAD Algorithm for Calculation of Degrees of Importance of Components in Fault-Tolerant Control Systems[J].Control Theory and Technology,1993,10(3):340~345.[点击复制] |
|
| 容错控制系统部件重要度计算的CAD算法 |
| A CAD Algorithm for Calculation of Degrees of Importance of Components in Fault-Tolerant Control Systems |
| 摘要点击 1196 全文点击 503 投稿时间：1991-08-19 修订日期：1992-01-03 |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| DOI编号 |
| 1993,10(3):340-345 |
| 中文关键词 重要度 容错控制 传感器 执行器 故障 |
| 英文关键词 degree of importance fault -tolerant control sensors actuators failure |
| 基金项目 |
|
| 中文摘要 |
| 部件（如传感器或执行器）的实效将导致系统性能的下降甚至完全实效。因此，在设计容错控制系统时确定部件重要度是非常重要的。本文提出了部件静态和动态重要度，它们分别表示了部件实效对系统静态和动态性能的影响程度。借助仿真和矩阵转换的运算，本文提出了能同时计算m个部件静态和动态重要度的CAD算法，例子验证了该法的有效性。 |
| 英文摘要 |
| Failure of component, such as a sensor or an actuator, may results in deterioration of properties or even complete failure of a control system. Therefore, it is very important to determine the degree of importance of a component in the design process of a fault-tolerant control system. In this paper, both degrees of static and dynamic importance of a component are presented, which denote the changed amplitude of static and dynamic properties respectively when a step change occurs in the out-put of a component. After simulation of control system and computation of transfer matrix, a CAD algorithm is presented, which can simultaneously compute degree of static and dynamic importance of a components. An example showing computation of degrees of importance in a process control system is studied, and the theoretical results are vertified by experiment. |
|
|
|
|
|