| 引用本文: | 刘 清,曹国华.模型参考和误差白化的传感器动态补偿算法[J].控制理论与应用,2009,26(3):256~260.[点击复制] |
| LIU Qing,CAO Guo-hua.Reference-model and error-whitening in dynamic compensation for sensors[J].Control Theory and Technology,2009,26(3):256~260.[点击复制] |
|
| 模型参考和误差白化的传感器动态补偿算法 |
| Reference-model and error-whitening in dynamic compensation for sensors |
| 摘要点击 1857 全文点击 1320 投稿时间：2007-12-09 修订日期：2008-07-04 |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| DOI编号 10.7641/j.issn.1000-8152.2009.3.005 |
| 2009,26(3):256-260 |
| 中文关键词 传感器 动态测量 补偿 参数优化 误差白化 |
| 英文关键词 sensor dynamic measurement compensation parameter optimization error whitening |
| 基金项目 国家自然科学基金资助项目(60774060); 江苏省高校自然科学基金资助项目(06KJD520099, 07KJD510111). |
|
| 中文摘要 |
| 通过模型参考的系统辨识方法建立传感器的动态补偿器, 常用的系统辨识采用均方误差(mean square error, MSE)为评判标准. 但是, 由于测量噪声存在和补偿器的频率特性, 使得补偿器的输入/输出信号存在严重的噪声干扰, 采用MSE为评判标准的系统辨识方法, 无法得到最优的补偿器的参数. 为此, 本文研究了一种以误差白化(error whitening criterion, EWC)为评判标准, 设计传感器动态补偿器的系统辨识方法. 该方法无需事先已知系统的动态特性, 根据传感器以及参考模型对 |
| 英文摘要 |
| The dynamic compensator for a sensor can be modeled with a reference model identified by the MSE(mean square error) criterion. However, only the biased estimates of the parameters can be obtained due to the contamination of high level noises in the output/input signals and the limited frequency response range of the compensator. To tackle this problem, the error whitening criterion(EWC) is proposed by which a dynamic compensator can be designed without knowing the dynamic characteristics of sensor. Based on the step-input responses of the sensor and the reference model, the compensator parameters are estimated by the EWC. Finally, experimental results show that this approach is effective. |
|
|
|
|
|