| 引用本文: | 余卓平,王婧佳,熊璐,徐松云.电液制动系统液压力控制[J].控制理论与应用,2016,33(7):897~902.[点击复制] |
| YU Zhuo-ping,WANG Jing-jia,XIONG Lu,XU Song-yun.Hydraulic pressure control of electro-hydraulic brake system[J].Control Theory and Technology,2016,33(7):897~902.[点击复制] |
|
| 电液制动系统液压力控制 |
| Hydraulic pressure control of electro-hydraulic brake system |
| 摘要点击 3266 全文点击 2681 投稿时间：2015-09-02 修订日期：2016-07-29 |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| DOI编号 10.7641/CTA.2016.50722 |
| 2016,33(7):897-902 |
| 中文关键词 电液制动系统 液压力控制 自适应控制系统 PID控制 滑模控制 |
| 英文关键词 electro-hydraulic brake system pressure control adaptive control systems PID control sliding mode control |
| 基金项目 国家“973”重点基础研究发展计划(2011CB711200)资助. |
|
| 中文摘要 |
| 电液制动系统(electro-hydraulic brake system, EHB)作为未来制动系统发展的重要方向, 已受到广泛关注.
本文基于一套自主设计的集成式电液制动系统(integrated electro-hydraulic brake system, I–EHB)系统进行研究, 为确
保其压力控制动态响应及精度, 克服工作中存在的延迟及能量损失, 设计了两种液压力控制方法, 分别是基于田口
方法优化的自适应PID控制和基于滑模变结构的补偿控制, 并搭建台架对两种控制方法进行测试. 通过对两种控制
方法下系统响应的比较分析, 发现滑模变结构补偿控制效果较好, 系统响应快、稳态误差小、鲁棒性好, 尤其在系统
常用的低频及中高压阶段控制表现突出, 验证了该方法的正确性和有效性, 并为进一步探索提出了方向. |
| 英文摘要 |
| The electro-hydraulic brake system (EHB) has become an increasingly promising research area. In this
paper, the pressure control method of a self-designed I--EHB (integrated electro-hydraulic brake) system were researched
to ensure the dynamic response of the system, and to balance the delay and loss of energy during work. Therefore, two
hydraulic pressure control methods, the optimized self-adaptive PID control based on the Taguchi method and the sliding
mode variable structure control (SMVSC), were designed and experimented on test bench. The paper compared these two
different control methods and the experiments revealed that the EHB system with SMVSC has shorter time delay, smaller
steady state error and better robustness with respect to integral controllability, especially when the target output is low
frequency average-high hydraulic pressure, which occurs mostly under normal working condition. Therefore, this paper
showed the effectiveness of the SMVSC and guides the further investigation of the hydraulic pressure control method. |
|
|
|
|
|